Currently Viewing Posts Tagged manual

Philips Universal Remote Control SRC2063


Instruction of Philips Perfect replacement Universal remote control SRC2063 6+3 combo pack. This is a guide to tell you how to program it, or how to choose the code for your TV, DVD, etc.

It is a combo pack. One SRP2003 for 3 different devices and one SRP2006 for 6 different devices.

Both remote controls work on TV, DVD players, Cable box, Satellite receiver, Blu-Ray player. SRP2006 can also work on VCR and DVR devices.


Here is an example show you how to set up the universal remote controls for TV.

1. Turn ON the TV manually or use the original remote control for it. Tune to channel 1.

2. Press and hold the “TV” device selection button for 5 seconds, until the red Setup light blinks. The remote control is now in setup mode for TV.

3. Look up the 4-digit code for your brand in the brand list at the back of the user manual. A 4-digit code is shown for each brand. Use the digit buttons to enter the code for your brand. If the red Setup light turns off, an invalid code was entered. In this case, try again.

4. Aim the remote control at the TV set. Press and hold the “Power” button. Release it immediately as soon as the TV turns off. This step normally takes between 5 and 60 seconds. In extreme circumstances this step can take up to 15 minutes.

Continue reading “Philips Universal Remote Control SRC2063”

Program Shaw Remote Control for Cable Box

The Shaw Digital Cable Box has no power button. So It is very important to record the manual way to program it. The universal way to program it without code is not working.
There four steps.
Step 1,
Turn on the Shaw Digital Cable Box by plugging the power cord.
Step 2,
On the remote control, press the device key: CBL
It will blink once. The press and hold SETUP until the selected mode key blinks twice.

Continue reading “Program Shaw Remote Control for Cable Box”

  • Archives