Raspberry Pi board is shipped board only. Nothing else. It is a barebon IC board.
So first I think it is good to give it a case.
To make a perfect paper Raspberry Pi case, followed the following guideline:
- Make sure to turn off ‘scale to fit’ in printer prefs before printing.
- Score card firmly on fold lines before folding.
It is easy to use. I found the printout pdf from the official site here.
- For best results cut with fine pointed knife andmetal safety ruler. Please be careful, and supervise children. I’m not responsible for cut
- fingers!
- Superglue or similar is best for gluing the tabs.
- Use the thickest card your printer will take. I used approx 300gsm.
