The Shaw Digital Cable Box has no power button. So It is very important to record the manual way to program it. The universal way to program it without code is not working.
There four steps.
Step 1,
Turn on the Shaw Digital Cable Box by plugging the power cord.
Step 2,
On the remote control, press the device key: CBL
It will blink once. The press and hold SETUP until the selected mode key blinks twice.


Step 3,
Enter four-digit code for Cable Box. I will put the potential code at the last.
If performed correctly, the selected mode key will blink twice.
If the selected mode key emits a long blink, the entry is invalid. Repeat step 2 through 3 an try entering the same code again.
Step 4,
Aim the remote control at the device and press PWR once. The Box device should turn off. If it does not, repeat step 2 through 3, trying each code I provide below.
The brand name of Shaw Digital Cable Box is Motorola.
Try following codes:
0476
0810
0276
1254
1106
1376
Mine is 0810.

David Yin

David is a blogger, geek, and web developer — founder of FreeInOutBoard.com. If you like his post, you can say thank you here

6 Replies to “Program Shaw Remote Control for Cable Box

Leave a Reply

Your email address will not be published. Required fields are marked *